'
怎么扩信道啊!~16个信道太少了!40个信道怎么扩啊?
'
坛子里专门有认讲过扩信道的，你可以搜索一下，有具体的图。
文章中讲扩信道16到40信道地在这里。
how to modify a 16 channel interface board to 40 channel amateur use, be careful check which type of board you have from the two diagrams below
怎样把16扩到40，要仔细从下面的判断中确定你的是哪种板子。
most of the radio needs to be disassembled to gain access to the interface board to prevent damage.
remove top & bottom lids.
remove 2 x large screws from front control head.
remove 3 x screws holding in the pll board with 2732 eprom.
remove two left hand side screws & locking bar.
disconnect two white connectors from main rf board.
remove 4 x screws holding pa section from back of set, important; note orientation of the two screening plate for reassembly. also how pins from pa section lock back into the vco & main rf board.
turn set over and remove 4 x screws holding main rf board in, desolder thin coax from vco to rf board, note location for resoldering on reassembly.
remove rf board by pushing out board from chassis.
remove 2 x screws & nuts holding in interface board.
carry out modifications as listed below, check which type of board you have.
将这段文字下面图中的板子拆出来，上面就是将怎样拆得，老外就是罗索。嘿嘿
