需要设置mic eq,国外的一些数值
i have done a lot of testing with the ft-2000 parametriq equalizer.
hopefully the ft-950 equalizer is identical in setup.
try these settings:
these have been tested using the md-100 microphone and gave great
results. this settings gave a rather "broad" ragchew ssb tx audio.
these also works great with the mh-31b8 original hand mic.
menu 064 (ssb tx bandwidth): 1-30 (100-3000 hz). setting at 2-28 (200-
2800 hz) gives a bandwidth of 2600hz and makes you sound more
narrow/sharp (better for dx ?).
parametriq eq (withouth proc)
menu 091 : 100
menu 092 : +6
menu 093 : 3
menu 094 : 1000
menu 095 : -5
menu 096 : 5
menu 097 : 3200
menu 098 : +10
menu 099 : 1
parametriq eq (with proc)
menu 100 : 100
menu 101 : -10
menu 102 : 6 to 8
menu 103 : 800
menu 104 : 0 to -3
menu 105 : 8
menu 106 : 2400 to 2600
menu 107 : +10
menu 108 : 1
menu 109 (proc gain): try 25% note !! distorts badly if turned up too
much !! use the monitor function and headphones to hear at which level
distortion starts.
important ! don't forget to push and hold menu for 2 seconds to exit
menu and store new settings !
mic gain at 11 - 12'o clock (watch the alc-level)
using proc really cuts throug in noisy band conditions. this is mostly
because of the difference in parametriq equalizer settings.
very important !
distance to md-100 : around 15-20 cm. (6-8 inches).
please set all controls underneath the md-100 in the off/thrue
position.
distance to mh-31b8 : around 8-10cm. (3-4 inches) any closer than 2
inches will create breathing noise (very unpleasant).
other menu settings :
menu 036 : a3e mic gain (am) : 90
menu 056 : f3e mic gain (fm) : 25
