MCU 2.27 / DSP 1.30, 11-10-2014
• RX I/Q PORT TURNED ON AUTOMATICALLY WITH PX3 ATTACHED: The KX3 now turns on the RX I/Q output whenever it detects an attached PX3. This eliminates the problem of image signals in the PX3 display due to RX I/Q being accidentally turned off.
• IMPROVED FIRMWARE LOADING: The KX3 now cleanly handles the case where new MCU firmware is incompatible with old DSP firmware in the middle of a full firmware load sequence. An error message may still appear in this case, but load timing will not be affected, allowing the new DSP firmware to be loaded correctly.
