SDR DDC HF Receiver based on UDPSDR-HF1 board
Use modern FPGA IV engine
It in enclosure - like on photo
Just rear cover open for USB and LAN output
Sample rate 384/1250 kHz.
SDR Used - have latest firmware - tested ans work FB
Original Screenshots here.
Work OK with SOFTWARE
Windows/Linux
PowerSDR, HDSDR, SDRSharp,QTRadio, have GNURadio block.
Included SDR receiver and CD with extio.dll and information.
SDR performance
100 kHz - 30MHz continuous coverage
LTC2249 14-bit @ 80MSPS ADC
LNA and 30MHz LPF
SMA external antenna jack
12-bit @ 48KSPS audio DAC with headphone output
Power requirements: USB powered via BeMicro SDK or external 5V@400mA
Uses BeMicro SDK for FPGA engine
LAN -I/Q data, power -USB or 5V
Attention
The user must know the subject SDR and understand that this project is in the development .
