怀疑是大家说的 “滤波器问题” 这个通病,或 “容易坏的” 高放管烧掉了。但手里没有维修手册,甚至没有综测…… 有点捉急。
这个视频有提到,换滤波器后,灵敏度大幅提高:
https://www.bilibili.com/video/BV1VZ4y187VT/在另一个网页说明中提到:
The Yaesu VX7R has a problem with it’s two ceramic 450 Khz IF filtersin that there was no DC blocking capacitor fitted to the outputcontrary to the filter manufacture’s recommendation. The result is thatthe filters ultimately fail.
There is no place on the pcb to fit asuitable capacitor. Also the pcb is doubled sided, so this presentsanother problem in installing the blocking capacitor, let alone that thetracks are very small.
This is the method I used to fit ablocking capacitor to both filters. Bending the filter’s o/p pin andusing a chip capacitor and a teflon covered wire (I used wire wrappingwire) is an easy solution to a design fault and ensures that the filtersare protected.
机翻,小修正:
Yaesu VX7R的两个陶瓷450 Khz IF滤波器存在问题,因为与滤波器制造商的建议相反,输出端没有安装直流阻断电容器。结果导致过滤器最终失效。
PCB上没有地方可以安装合适的电容器。此外,PCB是双面的,因此在安装阻挡电容器时会出现另一个问题,更不用说轨道(可能指的是PCB导线)很小了。
这是我用来在两个滤波器上安装阻挡电容器的方法。弯曲滤波器的o/p引脚并使用片状电容器和聚四氟乙烯包覆导线(我使用了被复线)是设计故障的简单解决方案,并确保滤波器受到保护。
但并没有具体说明。
求助各位前辈,有木有资料可以提供?我觉得,我的7R 它还可以挽救一下……