Welcome to the k3ng_cw_keyer wiki!
Look to the right for documentation and help topics ---->
(Like most things in the open source world, this wiki is under construction / evolving. If you would like to volunteer to help make it better, your assistance would greatly appreciated and your name and callsign would be immortalized as a supporter of this project.)
The K3NG Keyer is an open source Arduino based CW (Morse Code) keyer with a lot of features and flexibility, rivaling commercial keyers which often cost significantly more. The code can be used with a full blown Arduino board or an AVR microcontroller chip can be programmed and used directly in a circuit. This keyer is suitable as a standalone keyer or for use permanently installed inside a rig, especially homebrew QRP rigs. It’s open source code so you can fully customize it to fit your needs and also perhaps learn from it or find coding ideas for other projects.
A circuit board and parts kits called the nanoKeyer is available from DJ0MY, and Hamshop offers a kit called Open CW Keyer which uses this software. RemoteQTH also offers the Open Interface which runs this code.
Features
功能
特征
CW速度从1到999 WPM可调
通过USB端口编程和接口(“命令行接口”)
通用PS2键盘接口而无需计算机的键盘操作发射CW
通过K1EL Winkey 1.0和2.0接口协议仿真进行日志记录和竞赛程序接口
可选的PTT输出,具有可配置的前置、后置和悬挂时间
可选液晶显示器–经典4位模式,I2C的液晶模块
多达12个带有宏的存储器
比赛中可以使用自动序列号
速度电位计(可选——速度也可通过命令调节)
QRSS和HSCW
信标/FOX模式
自动键 A和B
手键模式
多模式
臭虫键Bug模式
CMOS超级键盘抑扬格B计时
点划方向调整
Hellschreiber模式(键盘发送、内存宏、信标)
法恩斯沃斯计时
可调频率侧音
侧音禁用/侧音高/低输出,用于键控外侧音频振荡器
命令模式用于使用拨片改变设置、程序存储器等。
键控补偿
滴答比率调整
额外的呼号接收练习
发送练习
内存堆叠
“看门狗监视器,防止误操作锁死”
自动设置拍发间隔
单词空间调整
预配置和定制工艺
大多数设置的非易失性存储
模块化代码设计允许选择功能和轻松修改代码
非英语字符支持
连续波接收解码器
休眠方式
梅休发光二极管环形支架
字母发送练习
QLF /“凌乱”直键模拟
发射/接收序列发生器
自我训练模块
前面板,后面换铝基板的
TYPE C的插口,配线好找,现在大家都是这种插口的手机了
第一批外壳,后面换成黑色的,因为暂时商家没货了。
BH4XDZ老师修改的使用说明
[ 此帖被BG6JJI在2021-09-25 22:49重新编辑 ]