说明书上抄下来的
azimuth a-d calibration
r from the controller panel, set the azimuth rotator fully
clockwise (to the right).
r press [f]Ž[¿] (f and enter) on the computer keyboard
to activate the control interface’s azimuth a-d converter
calibration routine. the computer’s display should show
+aaaa, where aaaa is a four-digit number which indicates
the azimuth heading in degrees.
r adjust the out vol adj potentiometer on the “azimuth”
(left) side of the controller rear panel so as to get
a reading of “0450” on the computer’s display. this
reading (“0450: 360 degrees + 90 degrees”) corresponds
to the actual beam heading you established when
you pointed the azimuth rotator fully clockwise.
r turn off the gs-232a’s power switch to exit the azimuth
a-d converter calibration routine, then turn on the
gs-232a’s power switch again.
把旋转器调到最大方位角
在超级终端键入f后按回车
调整out vol adj,使gs-232返回的数据对应你旋转器的最大方位角。
elevation a-d calibration
r from the controller panel, set the elevation rotator to
full scal (180°: “right” horizon).
r press [f2]Ž[¿] (f, 2, and enter) on the computer keyboard
to activate the control interface’s elevation a-d
converter calibration routine. the computer will display
+aaaa+eeee, where eeee is a four-digit number which
indicates the elevation heading in degrees. for the purposes
of this alignment, you may ignore the (azimuth)
aaaa numbers.
r adjust the out vol adj potentiometer on the “elevation”
(right) side of the controller rear panel so as to
get a reading of “0180” on the computer’s display.
this reading (“180 degrees”) corresponds to the actual
beam heading you established when you pointed the
elevation rotator to the 180° position.
r turn off the gs-232a’s power switch to exit the elevation
a-d converter calibration routine, then turn on
the gs-232a’s power switch again to turn it back on.
把仰角器调到最大仰角
在超级终端键入f2后按回车
调整out vol adj,使gs-232返回的数据对应你仰角器的最大仰角。