http://www.ir3ip.net/projects/standard/c520.mod.txt standard c520/528 - keypad guide |
|---------------------------------------------------------------------------|
|key| alone | with "func" key | key alone in set |in set with "f" |
|---------------------------------------------------------------------------|
| 0 | 0 |enter set mode |mute keypad bleep |set band edge limit|
| 1 | 1 |ptt lock |1/5 beeps when paged|tx wait on c-b rept|
| 2 | 2 |dual watch |1khz entry on keypad|match ctcss on scan|
| 3 | 3 |output power |tx delay on repeater|switch uhf bands |
| 4 | 4 |frequency lock |mute noises dur sql |dir input 4/3 figrs|
| 5 | 5 |battery saver |automatic power off |no audio after page|
| 6 | 6 |select step size |enable tune in lock |fast tune 1mhz/100k|
| 7 | 7 |ctcss select tx/rx |ctcss tone frequency|single/dual tone mf|
| 8 | 8 |repeater shift +/- |set tx/rx split freq|cross band repeater|
| 9 | 9 |reverse repeat shift|make lamp button rev|up/dn keys do 10mhz|
| * |step down|search 1mhz band | | |
| # |step up |memory shift | | |
| a |cancel | | | |
| b |pager on |set pager codes | | |
| c |mem scan |partial memory scan | | |
| d |dial/mem |store dial in memory| |extend rx coverage |
|---------------------------------------------------------------------------|
| expand:vhf f+0 f+d a | independent transmit/receive frequency |
| uhf f+l f+0 f+b f+l f+3 a | [rx] f+d <mem> [tx] f+d f+a f+<mem> a |
| vhf f+6 step to 12.5mhz a | remove independent tx freq from memory |
| f+8 f+8 f+c | f+d f+a <mem>+a f+a a |
| tune down to 144.9875 | clone one set to another |
| f+0 f+d ptt f+8 f+c | b b f+0 f+* [ptt] on source set |
\---------------------------------------------------------------------------/
origin 2:252/140 @ fido :: 17/09/91 ::
sysop@f140.n252.z2.fidonet.org ==============================================================================