求助Motorola MICOM-2 HF-SSB Transnsceiver机 [复制链接]

中文说明书、写频线、micom-2h面板可不可以手置频。

可以手动置频，也可以电脑写频。
rj-45 plug / db-9 jack

pin 7- receive data   -----   pin 3- transmit data
pin 6- transmit data   -----   pin 2- receive data
pin 5- ground       -----   pin 5- ground

最好用后面的扩展口的接口写频。
nout of the 25 pin accessory connector (j3):
pin no.      pin name      description
1      spkr-      differential output to the external 8ohm, 8w spkr
2      spare      
3      spkr+      differential output to the external 8ohm, 8w speaker
4      rx audio+      differential output of received audio signals (0dbm; 600ohm; not controlled by volume)
5      rx audio-      differential output of received audio signals (0dbm; 600ohm; not controlled by volume)
6      tx audio+      differential input received audio signals (600ohm impedance; -9 to 0dbm is required for full power)
7      tx audio-      differential input audio signals (600ohm impedance; -9 to 0 dbm is required for full power)
8      ptt_in voice      transmission command (by short to ground) for voice signals
9      ptt_in data      transmission command (by short to ground) for data signals
10      ptt_in cw      transmission command (by short to ground) for cw (morse) signals
11      sw a+      13.8v (nominal) current limited
12      kw_c_c      kw option channel change
13      kw_on/off      kw option power on/off
14      agc fast/slow      agc fast or slow release
15      rxd      point to point communication line to host/hlc
16      txd      point to point communication line to host/hlc
17      reset      external reset
18      gnd      ground
19      kw ptt      kw ptt
20      ext_alarm      external alarm operation (open collector - pulled to ground when external alarm is activated)
21      vpp      flash programming voltage
22      kw_alc      kw_alc
23      sq_gate      squelch indication
24      fan on/off      fan on/off
25      kw tune      kw tune

我是micom-2面板。http://www.motorola.com/governmentandenterprise/contentdir/en_us/files/productinformation/micomhf_ssb_specheet.pdf

我的也是这样的。

请问电间接那里，10脚要不要加600hz音频。

看看吧！！！

我的是全新单位库存货。接收正常，发射出不了功率。

給我電話吧。

'

我的是全新单位库存货。接收正常，发射出不了功率。

'
你该不会是没有对着话筒吼吧？！
另外，你的机器是micom-2h还是micom-2m？

是对着话筒吼！  
另外，机器是micom-2。

可以手动置频，也可以电脑写频

有一台2m的，但点不亮了，但估计问题不大，只是不知道后面板上的天线座是什么规格的。

请教手动置频的方法

ba4rz:看看吧！！！ (2008-03-17 16:35) 

BA4RZ你的联系方式能给我一下吗？

ba4rz:看看吧！！！ (2008-03-17 16:35) 

各选项的开通怎么弄，能指导一下吗？